1. The vibration frequency of the vibration system of the concrete production base is set to
2. Before the start of vibration, it should be confirmed that there are no underground pipelines such as water, gas, cable and sewage pipes. These devices are also susceptible to damage from vibration or explosion.
3. The vibration of the steel wheel will reduce the adhesion of the steel wheel to the ground. Therefore, when handling hard or passing a ramp, the machine may slip or even tip over.
For safety reasons, the machine has no vibration function in the "precision walking" mode. When the vibration is turned on, the pulley vibrates together with the vibrator. This vibration effect increases the pressure of the machine on the pavement material. The tamper can have two amplitudes and different vibration frequencies corresponding to different amplitudes. The vibration system is controlled by Hammtronic to achieve a stable vibration frequency. The vibration frequency is set by the trim switch. If the engine speed changes due to external reasons, it is calculated and compensated by the control system to obtain a stable vibration frequency.
Pay attention to the following when walking the tamper.
1. Vibration should not be opened near buildings and bridges as it may cause damage to these facilities. Our company mainly produces HC series 2.5-7 tons high speed hydraulic boring machine, HH series 2.5-7 ton high speed hydraulic boring machine, VC series 50-600kNU hydraulic vibration boring machine, HD series 160-3200kNU vibration boring machine and VH series vibration boring machine. . Development and production of various special hydraulic high-frequency vibrators (vibrators), such as artificial marble molding vibrators, crusher vibrators, unloading vibrators, etc.
