Introduction of ripper
The ripper is hung from the rear of the bulldozer or grader. The bulldozer or grader can press the loose teeth of the ripper into the work surface according to the construction needs, and carry out loose soil operation, smashing frozen soil, rock or hard road surface. The ripper has poor working conditions and is subject to a large pulling force during operation.
1. What is the ripper?
The ripper is a welded joint member, also known as a tail hook. The components include a bucket ear, an ear plate, a main board, a bottom plate, and a tooth. Some will add spring steel plates in front of the motherboard to increase the wear resistance of the board.
Second, the plane cutting angle of the tip of the ripper should be curved with the line in front of the motherboard.
Since the arc is not easily deformed by external force, the arc is relatively stable. At the same time, since the top of the tooth and the main plate are curved, it is easier to enter the ground for work.
Third, what should you pay attention to when buying ripper?
Pay attention to the materials when purchasing. The main board, ear plate and seat plate of the general ripper are Q345 manganese plates. There are large differences in the use rate and use time of ripper for different materials.
4. How to check the material of the ripper when purchasing?
A good ripper tooth should be rock-type, and the teeth are sharper than the earth's teeth. The advantage is that it is not easy to wear.
5. What should I pay attention to when ordering?
When ordering the ripper, the diameter, installation size, distance of the pin arm guard, etc. should be confirmed. The size of the ripper is the same as that of the bucket.
